If you say that a tire blows out when you are out, then you may need to use a hydraulic vehicle positioning jacks or hydraulic air bottle jacks when you need to change it, so how do we usually do it? Take a look at the following experience introduction.

  First, stop the car and make sure that it stops completely.

  Second, take out the jack from the trunk. Generally, the jack is put together with the spare tire. In addition, the jack that comes with the car is dedicated to the special car. You cannot use the small jack to jack the big car. It won't work.

  Third, find a support point for the jack under the car. This is something that many car owners and friends can easily do wrong, and it is also the most dangerous thing. If you don't find the right one, you will probably top the bottom of the car. Generally, when you lower your head and look down, there will be some obvious marks on the underside of the car. Either it is raised or the recessed part, which is a stiffener, so means the jack has to be pushed up. On the ribs, if you push it elsewhere, it will easily hurt the bottom of the car.

  Fourth, raise the jack. For the sake of safety, I suggest that all car owners and friends can always keep a set of gloves in the car so that we can prevent hand injuries when we use them. After manually raising the jack, align it with the support point just found. After aligning with the support point, we manually tighten it first, making it difficult. You can see that the groove just hits the rib. One thing to note here is that our car must be parked on flat ground. You should not park on a slope or on some soft grass. Otherwise, the jack will be unbalanced and the car will be easily let go. Fell down.

  After the jack has been strained, the hole can be inserted into the connecting rod with a sleeve. In this way, you can rotate clockwise and let the jack rise slowly.

When the height of the lift is about the same as the width of the finger, we will use the jack to lift the wheel, and the tire can be replaced later.

Jiaxing Mingrui Technology Co., Ltd. is a supplier of vehicle positioning jacks. The company has been selling long ram jacks for a long time. At the same time, as a motorcycle lifts supplier, the company also sells products such as mini car lifts.