Introduction To Fluorinated solvent Test

Comments · 1031 Views

Chlorodifluoromethane R-22 evaporation pretreatment degreasing device (see picture)

1. When the degreaser lifts the oil out of the liquid surface, it can be discharged from the oil drain port on the device

  1. Fluorinated Solvent wastewater tar experiment
  2. Measure 300ml of MVR oily wastewater during standard burning, add JZD-1601A degreaser 300PPM, heat and cook, about 10-20 minutes later, the upper layer of the beaker will produce oily flocculation. See picture

2 Description: After heating, the degreaser JZD-1601A can disperse the tar in the waste water and lift up the liquid surface of the waste water. If a degreasing device is installed, it is suitable for removing oil slick.

  1. Chlorodifluoromethane R-22 evaporation pretreatment degreasing device (see picture)
  2. When the degreaser lifts the oil out of the liquid surface, it can be discharged from the oil drain port on the device
  3. Oil-free wastewater enters the evaporation system from the outlet below
Comments