Gasoline Log Splitter will inevitably produce some slag when cutting wood. There is no problem at the beginning, but over time, as more and more slag accumulates, it will affect the efficiency and stable operation of the equipment. In this case, how to properly dispose of these slags, or is there any way to reduce the appearance of slags?
　　 1. Adding too much wood chip machine blades will also cause a large number of debris to appear, which can reduce the number of blades.
　　 2. Choosing a suitable wood chip machine to work can effectively reduce the generation of slag. This mainly depends on the local working environment to determine which machine to use, and choosing the right machine can better improve work efficiency. Inappropriate products will inevitably cause various problems during use.
　　 3. The gap between the fixed knife and the movable knife is too small, and the gap distance between the fixed knife and the movable knife should be adjusted according to the corresponding standards to allow it to operate normally.
According to Log Splitter manufacturers, the excessive slag in the use of the wood chip machine is mostly caused by the user’s failure to grasp the correct method of use, such as poorly adjusting the distance between the relevant parts of the equipment and the working environment. Unreasonable, the number of blades installed does not meet the requirements of use, etc., all of which may cause excessive slag in the equipment, resulting in a decrease in the efficiency of the equipment, so such problems should be avoided during use.