The times are changing. Now the machinery and equipment we need to apply are constantly being researched and developed, and new machinery and equipment are constantly being added, industrial, or article processing, or packaging, production, etc., and these machinery The emergence of has brought certain changes to our economy. Therefore, we have to thank the emergence of these machinery and equipment, which makes our lives better and better, but we are not studying machinery. Well, many people do not know the application characteristics of these mechanical equipment, such as the use of stereotypes, what are the operating methods?

1. After Stenter is powered on, wait for the computer program to run and then select. Note that the machine cannot be powered on immediately after power failure or power off immediately after power on. Clean the filter screen before driving.
2. When doing the needle plate task, it is necessary to ensure that the cloth clip parts are in the standby state, including the opening plate, cloth support plate, and probe positions of the front and rear cars. When making the cloth clip, ensure that the needle plate parts are in the standby state including the needle wheel and the needle removal. Disc, etc., after selecting the needle plate or cloth clip, let the chain run, and the others do not run, turn on the circulation fan, turn on the heating valve, select the required temperature such as 180℃, or 200℃, etc., adjust the width of the screw rod to the required process width Width, note: the width of the first screw must be the same as the width of the incoming cloth, and the tentering product must be gradually pulled apart from the second screw. The maximum deviation of the two adjacent screws cannot exceed 16cm. After the hanging cloth production is reached, the cloth feeder must pay attention to the width of the needle during the production. The cloth surface should not be wrinkled during the needle. Properly adjusting the speed of the brush wheel will improve the wrinkling problem. The speed should be as slow as possible as long as there is no wrinkle.
3. The Stenter cloth stopper should pay attention to the consistency of the width of the cloth and the width required by the process. If necessary, adjust it on the cloth discharging operation table. Pay attention to the fine adjustment of the speed of 3# overfeed and the fine adjustment of the width of 10# screw. It is helpful to improve the effect of needle removal.
4. When turning the needle plate, use a small turning splint, and when turning the needle plate, use two turning splints. Note that the speed at this time can only be the lowest speed.
5. After the Open Type Rotary Screen Printing Machine is finished, turn off the heating switch, keep the circulating fan running, the exhaust fan will continue to run, and the chain will continue to run until the drying room temperature is below 80℃. When the temperature drops below 80℃, the machine has stopped, and the circulation fan and exhaust fan have been turned off. The main power can be turned off. The personnel can only leave after the computer has completely stopped.