grinding and dust removal table Motor and fan are arranged in the upper shell, dust bag, hopper and dust pickup bucket are arranged in the lower shell, dust is installed between the upper shell and the lower shell, dust bag is connected with the filter rack, elastic gasket is arranged between the rack and the filter rack, vibration motor is connected with the filter rack through the vibration mechanism. An air inlet is arranged on one side of the lower shell, and an air outlet is arranged above the upper shell. The motor and vibration motor are respectively connected with the electric control box. The dust collector has the advantages of compact structure, easy operation, low noise, good dust removal effect, and can be directly used in small places and laboratories.

grinding and dust removal table selection is particularly simple, the following, for you to tell the specific method:

First, with the accumulation of dust on the surface of the filter material, the speed and resistance of the dust collector are increased correspondingly. When the pressure difference between the two sides of the filter material is very large, some of the fine dust particles attached to the filter material will be squeezed in the past, so that the speed of the dust collector will decrease.

Two, the dust collector resistance is too high will make the dust removal system air volume decreased significantly. Therefore, after the resistance of the dust collector reaches the value, the dust should be cleaned in time. Do not destroy the initial layer when cleaning, so as not to decrease the rate.

Three, mainly according to the user needs to dust the size of the need, and the site condition to decide, this dust collector equipment is simple in structure, easy to operate and maintain.

Four, filter material used for a period of time, due to screening, collision, retention, diffusion, electrostatic and other effects, the surface of the filter bag accumulated a layer of dust, this layer of dust is called the first layer, in the process of movement after this, the first layer became the main filter layer of the filter material, relying on the role of the first layer, large mesh filter material can also obtain a better filtration rate.

The dust-bearing gas enters the dust collector from the lower part of the dust collector and is filtered by the dust bag. The clean air is discharged by the induced draft fan. After the dust collector works for a period of time, the dust on the filter bag gradually increases, causing the negative force of the filter bag to rise. It is necessary to clean the dust, and the dust collector will work normally after the cleaning is completed. grinding and dust removal table unit has six specifications, divided into three,  unit As required, the lower part of the addition is directly connected to the dust-collecting equipment such as the top of the warehouse, the silo, and the transport point of belt transportation and transfer for local dust removal. The direct dust recovery dust removal table is installed near the mechanical equipment producing dust, and the user follows the size of the upper intake outlet of the dust collector. Equipped with metal or plastic pipes and dust cover (can also be designed by the manufacturer), before the dust collector work should check the access door, each flange connection is sealed, so as to avoid air leakage, reduce the dust removal effect. Dust collector is, voltage, from the dust collector external wire street power supply can start to use, the initial operation, should pay attention to the fan rotation direction (such as reversal, need to replace the power wiring. The cover of the dust collector control cabinet can not be opened at will in the studio. If it is necessary to adjust the dust cleaning time or overhaul the circuit, it should be stopped or cut off the power supply. According to the nature of dust and dust concentration, adjust the timing of cleaning. The dust cover is the key part of the dust collector in the state. The user should make the ideal dust cover by connecting according to the shape size of the workpiece and the nature of the dust, and designing the dust cover near, sealing and conveniently.

grinding and dust removal table https://www.kaisenfilter.com/grinding-and-dust-removal-table.html