Manual Seeder plays an important role in agricultural and forestry production. Many users will encounter various problems in the process of using it. Here is an introduction to the problems caused by misoperation.

1. Before using Manual Seeder, some users will check whether the screws around the body are tightened, and if the screws are loose, they will go back and tighten them. In fact, this is a wrong operation. Many accessories are made of aluminum alloy, and the hardness of aluminum alloy is not enough, if you screw it hard, it will cause wire drawing.
2. When the cover of the Manual Seeder fuel tank leaks, some users will choose to seal it with a film paper. This is wrong. This will cause the pressure in the fuel tank to decrease, resulting in a decrease in fuel supply, and ultimately causing the engine to emit black smoke and insufficient power.
3. The air-cooled Manual Seeder uses water to cool down during operation, which is also a wrong approach. At this time, the cylinder is in a state of high temperature and high pressure. If the temperature is suddenly cooled with cold water, the cylinder liner will suddenly shrink.
4. After the gaskets of the oil inlet and outlet of the Manual Seeder are damaged, the position is not paid attention to when reinstalling, resulting in poor sealing effect or blocking the inlet and outlet. In the light of the oil leakage, the oil does not circulate and the crankshaft, The coupling shaft cannot be effectively lubricated.
5. In order to save the cost of using Rice Planting Machine, some users use low-priced low-quality fuel, which not only makes the machine power insufficient, but also accelerates the wear of the oil pump and core sleeve in the long run. In the same way, poor-quality lubricants will also shorten the service life of the machine. Those common "recycled oil" must not be used indiscriminately.