The wool obtained by the batching of sawn timber and artificial boards. Often with large shape and size errors. Component processing. That is to say, the wool will be obtained by batching. Further processing to a clean material with the correct geometry and cross-sectional size and finish requirements ll"E. And a final finishing process to clean and sand the surface. Below, Wooden Toys Company describes the processing of the components:

(1) Machining of the reference surface and the opposite surface

In order to obtain the correct shape of the component. size and smooth finish. And to ensure the accurate positioning of subsequent processes. The base surface must be processed on the wool. It is the dimensional reference for subsequent processing. The reference plane includes the plane (large plane). Side (small face) and end face, etc. The datum surface processing can use manual planing or care about the planer. Finished on a milling machine. After the reference plane is processed. That is, several other surfaces can be machined based on the datum plane. in order to get the final level. Bright. Woodwork components with technically required shape and size specifications.

(2) Processing of tenon and tenon hole

Tenon joint is the most common basic joint form in frame wood product structure. Where this combination of sites is used. The tenon and tenon hole must be cut out on the corresponding parts respectively. Tenoning 1: The sequence is the main process of production and processing. The quality of processing directly affects the bonding strength and quality of the product. After opening the tenon. The machining datum and assembly datum of the subsequent process are formed on the part. So as to ensure that the manufactured parts and products can reach the required machining accuracy.

Through the above introduction, China Wooden Jewelry Exporter hopes that you can simply refer to the content of this article in future use.