Why did Lotion Pump Head Manufacturers' lotion pump stop working

The soap dispenser is a very reliable device. You press the finger pump, soap flows out of the spout, and the pump automatically retracts for the next cycle. But sometimes things inside the pump can get messed up.

When the pump does not work, it is usually because it is blocked or the spring is broken. But this is not always that simple.
What is the possible reason?

The soap dispenser is stuck: some pumps are locked abnormally. Opening it in the correct way may save you the trouble of dealing with damaged pumps later.
You can try to remove the pump from the bottle, rinse the shaft and wipe dry. Then, you will firmly grasp the shaft under the pump collar and twist it firmly to the right. This will turn on the pump, put the pump back in the bottle, and you can use the new product.

The spring may be damaged: the spring is installed in the pump tank. Although not every water dispenser can do this, some bathroom water dispensers allow you to separate the reservoir from the lid. You can unscrew it and replace it with a new spring available in any hardware store.
The pump does not dispense any soap: the pump may appear to be running, but you are not getting any soap. Check if you don't have soap. If there is still soap remaining, the dip tube of the pump may be too short to reach the bottom.
In some cases, the dispenser itself is blocked. The soap may have dried up in the tube, blocking it. You can try to take the pump out of the bottle and wash and dry to use it again. It almost always helps to resolve any type of blockage.

If none of these procedures can repair your pump, it may be because the internal seals are damaged. If this is a commercial dispenser or a dispenser built into the sink, you can take it apart, find the damaged part, and then replace only the damaged part.

For more product-related information, please click: Cosmetic Packaging Factory