How to maintain the Chipper Shredder, but all Chipper Shredder products have their service life. Good maintenance measures can increase the service life of the equipment and at the same time improve the quality and efficiency of product processing. Chipper Shredder is nothing more than. There are roughly three daily maintenance measures for Chipper Shredder: 1. Cleaning and maintenance. 2. Lubrication and maintenance. 3. Fastening and maintenance. These three are not only for Chipper Shredder, but are also effective for other products.

　　 1. This series of equipment adopts the rotor peeling method. After Chipper Shredder is put into operation for a period of continuous use (according to different usage conditions, within one month of normal use), it should be thoroughly cleaned and replaced with lubricating oil.

　　2. During normal operation and processing of Chipper Shredder, the temperature of the main bearing should not exceed 65%. For the transmission bearing and reducer of the machine, the temperature should not exceed 65%, and the maximum temperature is 70°.
　　3. In the processing of woodworking machinery, noise is unavoidable. Therefore, in use, the noise of the machine is an important label that determines the state of the machine. Noise During operation, the noise is different according to the amount of material fed. It should be fed in a uniform feeding method and according to the amount of noise. If abnormal noise occurs during processing, it should be shut down immediately for inspection.

　　4. Whether the connection of each component of the Rapid Splitter is loose, check whether the screws are fastened, whether there is any looseness in the place where the machine is installed, and if any abnormalities are found, it should be investigated immediately.

　　5. Frequently clean the dust and dirt of the motor brushes and contact points to ensure cleanliness and good contact.

　　6. ​​Keep all contacts clean and keep them in good contact.

　　7. Whether the tightness of the power transmission part, especially the belt (V-belt) is too loose or too tight, the terminals of the motor and the regulator must be firmly connected, and the wires shall not be broken or broken.

　　 For the maintenance of the Rapid Splitter, following the above correct method is the main way to ensure the normal operation of the machine. During processing, the working environment of the Rapid Splitter should be avoided too much dust, which can shorten the maintenance time. When the workload is heavy, the frequency of maintenance should be increased to avoid some mechanical accidents.