Adjust the thermostat to the desired temperature. When the temperature of fully automatic heat transfer printing machine reaches the set temperature, the indicator on the upper part of the thermostat off, and then the thermostat can start to work.

Adjust the time controller to the required time.

Place the clothes flat on the lower ironing board, then put the hot stamping paper (note the front and back of the hot stamping paper), press the handle down vigorously until the end point. Note: do not exert more than 30 kg, otherwise the handle may be deformed.

When indicating the time of the hot stamping time controller, the buzzer will sound, and the handle will be lifted upward to the original position.

Matters needing attention:
Pressure: if the pressure is not enough or too large, The pressure adjusting knob can be adjusted to increase the pressure in the clockwise direction; Conversely, it reduces stress;

Time: when the hot stamping time arrives and the buzzer does not sound or keeps ringing, if it is uncomfortable, it must be adjusted to the appropriate position;

temperature: when the temperature is reached, the thermostat pointer refers to the position of “180℃” (about 5 minutes to reach), if the starting thermometer rises and the heating plate does not heat, please check the circuit.

When the handle is pressed to the bottom, release the hand and the handle will rise automatically. Please adjust the adjusting knob downward.

When the hot stamping is finished and the handle is lifted upward, the adjusting knob can be adjusted downward.

We are one of the heat transfer foil suppliers and welcome you to send us messages!