The aluminum-separator filters supplier is an automated pressure-type filtration device. It is mainly composed of a cylinder, filter element, filter cloth, filter aid, computer control system and accessories, etc. As a large-scale equipment on the production line, this filter is usually also called a candle filter. To enable customers to promptly address any issues that arise during use, today, Liferite has compiled some solutions to related faults for everyone.

Fault causes and Solutions of aluminum-separator filters supplier:

I. The flow of aluminum-separator filters supplier has sharply decreased:

1. The end cover is not tight. Tighten the end cover

2. The piping valve is not opened. Open the valve

3. Low intake pressure; Check the cause and increase the intake pressure

4. The O-ring seal is leaking air. Exchange

5. Air leakage in the piping; Repair piping

Ii. Increased pressure drop of aluminum-separator filters supplier:

1. The filter element is clogged or has a large adsorption capacity; Replace the filter element

2. Aging of the filter element Replace the filter element

3. Large load of impurities in the intake air; Carry out pretreatment

4. Water accumulation in the filter cartridge; Find out the cause and drain the accumulated water

5. The automatic drain malfunctions. Adjust, repair or replace the drain

6. The filter is not installed horizontally; Reinstall

Iii. Poor filtering effect of aluminum-separator filters supplier:

1. The intake air was not pre-treated; Add a pre-filter

2. Aging of the filter element Change and adjust the filter element

3. The air contains chemical substances that the filter element cannot adsorb. Deal with the situation in advance

4. The flow rate exceeds the rated value; Replace the high-flow filter

5. There is a short circuit of air flow inside the filter. Find out the cause and deal with it accordingly

6. The filter element's fastening screws are not tightened. Tighten the filter element

7. The inlet and outlet of the filter are connected in reverse. Reconnect in the marked direction

8. The downstream pipelines are not clean; Flush the downstream pipeline

9. There are residual contaminants at the usage point; Remove residual pollutants

10. The bypass valve was not closed tightly. Tighten the bypass valve tightly

Iv. The aluminum-separator filters supplier is not working:

1. The inlet and outlet valves are not open. Open the valve

2. The filter element is severely clogged; Replace the filter element

3. The filter is damaged; Replace the filter

4. Pipe blockage; Repair piping

The above are the product malfunction problems and solutions of the aluminum-separator filters supplier. If such a situation occurs during your use, you can solve it in a timely manner according to the relevant solutions later. If you have any other problems, you are welcome to contact us at any time. Ensure the normal operation of the products and production support.

aluminum-separator filters supplier https://www.ast-filter.com/Heat-resistance-separator-filter.html