function of cyclone test should pay attention to what are the problems?

Comments · 321 Views

function of cyclone https://www.kaisenfilter.com/What-is-the-function-of-cyclone-separator.html

function of cyclone is composed of air inlet pipe, air exhaust pipe, box, ash bucket, ash cleaning device, diversion device, air distribution plate, filter cylinder and electronic control device, similar to pulse bag dust collection structure. The layout of the function of cyclone is very important. It can be arranged vertically on the flower plate of the box body or tilted on the flower plate. From the effect of cleaning ash, the vertical layout is more correct. The lower part of the flower plate is the filter chamber and the upper part is the pulse chamber. A airflow distribution plate is installed at the inlet of the dust collector.

function of cyclone test should pay attention to what are the problems? The following, for you to talk about in detail:

First, test verification: for the defects and hidden dangers found in the no-load test, after repair and treatment, to go through one or more test to verify; To be confirmed by test run verification. Reach the design target.

2. Circuit inspection: The circuit inspection of the dust removal system (especially the dust collector) is mainly to observe the dynamic operation of the no-load test, discover the problems, timely deal with the potential uncertainties in the installation process of dust removal equipment, correct errors, and improve the sound string of dust removal equipment.

3. Deal with defects: All equipment defects and hidden dangers found in the process of no-load test should be recorded, carefully discussed, and repaired to prevent further thinking.

Four, the treatment of major hidden dangers, to stress the spirit, take technology on the basis of view and discussion, buy very remove defects, improve the quality of equipment installation.

5. No-load operation: under no-load (no dust) condition, organize and observe the operating conditions of the dust removal equipment, especially the voltage, current, speed and vibration of the main fan, as well as the air volume, resistance and electric field characteristics of the dust collector; The integrity, continuity and applicability of the dust collector were evaluated by macroscopic qualitative evaluation. The overall function of the equipment was matched, the operation was continuous and the function was suitable.

The basic structure of the function of cyclone consists of dust removal box, centrifugal fan, filter bag (filter cylinder), dust collector and microcomputer controller, etc. The dust is sucked inside the dust collector box by the negative pressure of the fan through the suction pipe, and the coarse particle dust is initially filtered by the filter and directly drops to the dust collector by gravity and the fine particle dust is captured on the outer surface by the filter. The clean gas flows into the clean room after filtration, decomposition and purification through the filter element, and is discharged from the outlet by the fan. The whole process of dust removal and filtration is a result of gravity, inertia force, collision, electrostatic adsorption, screening and other comprehensive effects.

function of cyclone consists of fan, filter and dust collector three parts, each part is installed in a vertical frame, steel shell, baking paint rust prevention, stable operation, easy to use. function of cyclone fan adopts centrifugal fan, large air volume, high wind pressure, and adopts noise reduction measures, low noise. Filter using flat cloth bag group, each bag is equipped with spring steel mesh, filtering effect is good. The flyaway mechanism uses the motor to drive the eccentric wheel and connecting rod to make the bag shake and stick to the dust on the surface of the filter bag. This pulse spray function of cyclone dust collector is equipped with access door, convenient maintenance and bag change.

function of cyclone https://www.kaisenfilter.com/What-is-the-function-of-cyclone-separator.html

Comments