Treatment Of Enameled Aluminum Strip Paint Removal

Comments · 1346 Views

enameled aluminum strip paint remover is mainly composed of a variety of special organic ingredients, active substances, stabilizers, etc.,

  enameled aluminum strip paint remover is mainly composed of a variety of special organic ingredients, active substances, stabilizers, etc., which are used to remove the paint layer of enameled wire.

  1

   is generally used in the original solution and soaking method at room temperature. The enameled wire that needs to be stripped is pierced into the product, soaked for 2 minutes, the paint film will automatically fall off;

  2

   Wipe off the paint film with a rag.

  END Note 1. When using this product, the operator should wear protective rubber gloves. After the paint is stripped, the enameled copper square wire should be wiped with a rag to remove the remaining paint film to strengthen the paint stripping effect. 2. When there are too many precipitates in the paint remover, the impurities are filtered out, and the filtrate can be used continuously. When the paint removal effect is significantly reduced and the new liquid cannot reach the original level, it can be discarded and replaced with a new liquid. 3. This product is corrosive to some metals, so be careful when using it. This product can be filled with glass or ceramic containers. 4. Operators need to wear rubber protective gloves. Do not touch the skin and eyes. If the paint remover touches the skin, immediately rinse with a lot of water, then rub soap, rinse, and then apply dilute glycerin or seek medical attention. 5. This paint remover will burn the skin. When opening the lid of the paint remover packaging barrel, pay attention to the upward splash of the paint remover and hurt people. Before spraying or painting the paint, the paint remover must be stirred or shaken evenly before operation and construction.

 

Comments